Yamaha MX-A5000 Bedienungsanleitung Seite 7

7
INPUT (XLR) jack
For connecting to a pre-amplifier with XLR output jacks (p.6).
To use the XLR jack, set the corresponding BAL/UNBAL
switch to "BAL".
When connecting an XLR balanced cable, match the pins
and insert the "male" connector of the cable until you hear a
click.
XLR balanced cable (male)
• When disconnecting the cable from the unit, hold down the PUSH
button on the unit and then pull the connector out.
About the XLR jacks
• The pin assignments for the XLR jacks of the unit are shown
below. Before connecting an XLR balanced cable, refer to the
instruction manual of your pre-amplifier and verify that its XLR
output jacks are compatible with the pin assignments.
2. HOT 1. GND
3. COLD
8
INPUT (RCA) jack
For connecting to a pre-amplifier with RCA output jacks
(p.6).
To use the RCA jack, set the corresponding BAL/UNBAL
switch to "UNBAL".
RCA cable
RCA short pin
L .
U N B A
B A L .
• Remove the RCA short pins attached to the INPUT (RCA) jacks
before making connections. Be sure to keep them in a place
inaccessible to small children who may accidentally swallow
small parts.
• To protect against noise contamination, we recommend
attaching the RCA short pins when the INPUT (RCA) jacks are
not in use.
9
BAL/UNBAL switch
Switches between XLR input and RCA input for each channel
(p.6).
Part names and functions
En
5