Ac Power Connection; Remote Control; Battery Installation; Remote Sensor - Pioneer X-HM10-S Bedienungsanleitung

System connections (continued)
n AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
Caution:
l Handle the power cord by the plug part. Do not pull out
the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on the power
cord or pinch the cord in any other way. Never make a
knot in the cord or tie it with other cables. The power
cords should be routed so that they are not likely to be
stepped on. A damaged power cord can cause a fire or
give you an electric shock. Check the power cord once
in a while. If you find it damaged, ask your nearest
Pioneer authorized independent service company for a
replacement.
l Do not use any power cord other than the one supplied
with this unit.
l Do not use the supplied power cord for any purpose
other than that described above.
n Connecting a TV, etc.
Connect to the TV using an audio cable.
TV
Main unit
AC IN
To select Line In function:
l On main unit: Press INPUT button repeatedly until
Line In is displayed.
l On remote control: Press LINE button
repeatedly until Line In is displayed.
To audio
output sockets
Audio cable
(commercially
available)
To LINE
input
sockets
LINE AUX
LOOP

Remote control

n Battery installation
1
Open the battery cover.
2
Insert the supplied battery according to the direction
indicated in the battery compartment.
When inserting or removing the battery, push it towards the
(–) battery terminal.
3
Close the cover.
WARNNIG:
l Do not use or store battery in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause the battery to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of battery.
Caution:
l Remove the battery if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
l Do not use rechargeable battery (nickel-cadmium battery,
etc.).
l Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
l Replace the battery if the operating distance is reduced or
if the operation becomes erratic. Purchas an "AA" size
battery.
l Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
l Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
l Keep the remote control away from moisture, heat, shock,
and vibrations.
l When disposing of used battery, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
n Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the
unit. The remote control can be used within the range shown
below:

Remote sensor

7 m
STANDBY/ON
En-8