General Control; Setting The Clock (Remote Control Only); Volume Control; Input Button - Pioneer X-HM10-S Bedienungsanleitung

General control

STANDBY/ON
P.BASS
VOL VOL
STANDBY/ON
INPUT
n To turn the power on
Press the STANDBY/ON button to turn the power on.
After use:
Press the STANDBY/ON button to enter the power stand-by mode.
n Display brightness control
To dim the display brightness, press the DIMMER button on the
remote control.
Dimmer 1
Dimmer 2
Dimmer Off
n Volume auto set-in
If you turn off and on the main unit with the volume set to 17 or higher,
the volume starts at 16.
n Volume control
Turn the volume knob towards VOLUME (on main unit) or press VOL
+/– (on remote control) to increase or decrease the volume.
n Auto power on function
When you press any of the following buttons, the unit turns on.
l iPod / iPhone, CD, USB, LINE, TUNER on the remote control:
Selected function is activated.
/ button on the main unit: The unit turns on and playback of
l
the last function will start (CD, TUNER, USB, iPod, LINE IN)
n Auto power off function
The main unit will enter the stand-by mode (when iPod/iPhone is not
docked) after 15 minutes of inactivity during:
iPod/iPhone: No connection.
CD / USB: In the stop mode.
LINE IN:No detection of input signal or very low sound au-
dibility.
Note:
X-HM20 only: However, if iPod/iPhone is docked, the unit will begin
charging.
"Charge Mode" will be displayed during standby mode.
n Muting
The volume is muted temporarily when pressing the MUTE button on
the remote control. Press again to restore the volume.
DIMMER
BASS/TREBLE
MUTE
VOLUME
(Display is dim).
(Display gets dimmer).
(Display is bright).
n P.Bass control
When the power is first turned on, the unit will enter the P.bass mode
which emphasises the bass frequencies. To cancel the P.bass mode,
press the P.BASS button on the remote control.
n Bass control
1
Press the BASS/TREBLE button to select "Bass".
2
Within 5 seconds, press the VOL (+ or –) button to adjust the
bass.
n Treble control
1
Press the BASS/TREBLE button to select "Treble".
2
Within 5 seconds, press the VOL (+ or –) button to adjust the
treble.
n Function
When the INPUT button on main unit is pressed, the
current function will change to different mode. Press the
INPUT button repeatedly to select desired function.
FM STEREO
CD
Line In
(X-HM20 only)
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
Setting the clock (Remote control
only)
STANDBY/ON
TUNING −
In this example, the clock is set for the 24-hour (00:00) display.
1
Press the STANDBY/ON button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the ENTER button. To adjust the day,
press the or
En-9
........
-5 -4
........
-5 -4
FM MONO
USB
iPod
CLOCK/TIMER
TUNING ＋
ENTER
button and then press the ENTER button.
+4 +5
+4 +5
AM