Door Reversibility - AEG S72300DSW0 Benutzerhandbuch

38 www.aeg.com
LOCATION

DOOR REVERSIBILITY

100 mm
15 mm 15 mm
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net.To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between
the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however,
the appliance should not be positioned be-
low overhanging wall units. Accurate level-
ling is ensured by one or more adjustable
feet at the base of the cabinet. If the cabi-
net is placed in a corner and the side with
the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at
least 10 mm to allow the door to open
enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the opera-
tions.
To change the opening direction of the
door, do these steps:
Remove the plug from the power socket
Open the door of the freezer. Loosen the
hinge.