AEG S72300DSW0 Benutzerhandbuch Seite 35

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is too
high.
The temperature in
the freezer is too
high.
There is too much
frost.
Possible cause
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed cor-
rectly.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
35