How To Replace The Air Clean Filter; Replacing One Type Of Exhaust Filter With Another; When To Replace An Activeairclean 30 Filter Or A Hepa Airclean 30 Filter; How To Replace An Activeairclean 30 Filter Or A Hepa Airclean 30 Filter - Miele HS12 Gebrauchsanweisung

How to replace the Air Clean filter

(dia. 23)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
a Unclip the filter grille and raise it
upwards as far as it will go. Grasp
the used Air Clean filter by the clean,
unsoiled section (see arrow) and
take it out.
b Replace it with a new filter.
^ Close the filter grille.
^ Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner can be fitted with an
ActiveAirClean 30 filter or a HEPA
AirClean 30 filter instead of the
standard Air Clean filter.
To change the type of filter, the Air
Clean filter and the filter grille must first
be removed and the new type of filter
then fitted instead. Press the reset
button ~ for the exhaust filter change
indicator (dia. 24).
After approx. 10 - 15 seconds a thin red
stripe will appear in the left hand side of
the display (dia. 25).
When to replace an ActiveAirClean 30
filter or a HEPA AirClean 30 filter (dia.
26)
Replace if the display for the exhaust
filter change indicator is completely
filled with red.
This occurs after approx. 50 operating
hours, or approx. one year of average
use. The vacuum cleaner can still be
used with the exhaust filter indicator lit
up. However, the suction power will be
reduced as will the effectiveness of the
filter if it is not replaced in good time.
How to replace an ActiveAirClean 30
filter or a HEPA AirClean 30 filter
(dia. 27)
a Lift out the old exhaust filter.
b Replace it with a new filter.

When to change the thread lifters

The thread lifters on the suction inlet of
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.

How to replace the thread lifters

(dia. 28)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Replacement parts are available from
your Miele retailer or from Miele (see
back cover for contact details).
en
33