When To Change The Exhaust Filter; How To Replace The Air Clean Filter; How To Replace An Activeairclean 50 Filter Or A Hepa Airclean 50 Filter - Miele HS15 Gebrauchsanweisung

^ Open the blue filter frame and
remove the old filter. Hold by the
clean, unsoiled section to remove it.
^ Replace with a new dust
compartment filter.
^ Close the filter frame.
^ Insert the dustbag into the holder as
far as it will go.
^ Close the dust compartment lid
securely, making sure it clicks into
position. Take care not to trap the
dustbag when doing so.

When to change the exhaust filter

Depending on model, your vacuum
cleaner will be fitted as standard with one
of the following exhaust filters (dia. 9):
a Air Clean
Replace this filter every time you start a
new packet of Miele dustbags. An Air
Clean exhaust filter is supplied with
every packet of Miele dustbags.
b ActiveAirClean 50 (black)
c HEPA AirClean 50 (white)
Replace the exhaust filter if the exhaust
change filter indicator is completely red
(dia. 14).
This occurs after approx. 50 operating
hours, or approx. one year of average
use. The vacuum cleaner can still be
used. However, the suction power will
be reduced as will the effectiveness of
the filter if it is not replaced in good
time.

How to replace the Air Clean filter

(dia. 36 + 37)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Press the release catch on the filter
grille and open the grille until it clicks.
^ Hold the used Air Clean filter by one
of the clean, unsoiled sections.
^ Replace it with a new Air Clean filter.
If you wish to replace the Air Clean
filter with an ActiveAirClean 50 filter
or with an HEPA AirClean 50 filter,
see "Replacing one type of exhaust
filter with another".
^ Close the filter grille.
^ Close the dust compartment lid.
How to replace an ActiveAirClean 50
filter or a HEPA AirClean 50 filter
(dia. 38 + 39)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Lift the filter and remove it.
^ Replace with a new filter, and push it
down into place.
^ Press the exhaust filter change
indicator ~ (dia. 12).
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the strip (dia. 13).
en
45