Fitting A Dustbag; Replacing The Motor Protection Filter; When To Replace The Exhaust Filter; How To Replace The Exhaust Filter - Miele HS15 Gebrauchsanweisung

en
Fitting a dustbag (dia. 26)
 Fit the new dustbag into the holder as
far as it will go. Leave the dustbag
folded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
A safety device prevents the lid clos-
ing without a dustbag in place. Do
not force it.
 Insert the hose connector into the
suction opening on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces (dia. 01).

Replacing the motor protection filter

(dia. 27)
Replace the motor protection filter
whenever you start a new packet of
dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters (available depending on country).
 Open the dust compartment lid.
 Pull the dustbag out by the grip on
the collar.
 Lift up the filter frame until it clicks
and remove the old filter. Hold by the
clean, unsoiled section to remove it.
 Replace with a new motor protection
filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
42
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.

When to replace the exhaust filter

Replace the exhaust filter if the
timestrip® filter change indicator is
completely red (dia. 10).
The indicator lights up after approxim-
ately 50 hours of operation, which is
equivalent to about a year of average
use. You can continue vacuuming when
the light comes on. However, the suc-
tion power will be reduced as will the
effectiveness of the filter if it is not re-
placed in good time.
How to replace the exhaust
filter (dia. 28 + 29)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making it
sure it goes in properly, then push it
down into position.
 Press the timestrip® filter change in-
dicator on the exhaust filter (dia. 08).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (dia. 09).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
 Close the dust compartment lid.