Operation; Maintenance And Care - Kärcher WD 4200 Originalbetriebsanleitung

Operation

Always work with an inserted cartridge
filter - during wet as well as dry vacu-
um cleaning!
Before Startup

Illustration
Mount loose parts delivered with appli-
ance prior to start-up.

Illustration
Recommendation: To vacuum fine dust,
use the filter bag.
Start up

Illustration
Connect accessories.

Illustration
Plug in the main plug.

Illustration
Turn on the machine.
Dry vacuum cleaning
Work only with a dry cartridge filter!
Recommendation: To vacuum fine dust, use
the filter bag.
(see description / illustration

The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced more fre-
quently while sucking in fine dust, sand, etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!

Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
Wet vacuum cleaning

Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or di-
rectly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes the
suction opening and the appliance works at a
higher speed. Switch off the appliance imme-
diately and empty the container.
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from a
gravel bed.




Empty the container

Storing the appliance

)
Turn off the appliance and remove the mains
plug prior to any care and maintenance work.
Repair works may only be performed by the
authorized customer service.
Do not use abrasives, glass or universal clean-
ers! Never immerse the appliance in water.



– 3
EN
Blowing function
Illustration
Connect the suction hose to the blower
connection, this will activate the blower
function.
Interrupting operation
Turn off the appliance.
Illustration
Hook the floor nozzle into the parking po-
sition.
Finish operation
Turn off the appliance and disconnect the
mains plug.
Illustration
Remove the appliance head and empty
the reservoir.
Illustration
Stow away the mains cable, the mains ca-
ble retraction and accessory in the appli-
ance.
Store the appliance in a dry room.

Maintenance and care

Danger
Caution
Clean the appliance and accessory parts
made of plastic with a commercial plastic
cleaner.
If required, rinse the container and acces-
sories with water properly and dry them
before reuse.
Illustration
Only clean the cartridge filter under run-
ning water; do not wipe or brush. Let it dry
completely prior to installation.
11