Product Contents; Prior To Fi Rst Use; Unpacking; Assembly - Cleanmaxx VC9388 Gebrauchsanleitung

Product contents

1 x main unit 1 x midsection
with dirty
water tank
Prior to fi rst use
Before you use the device, you must do the following:
• unpack the product contents,
• assemble the device.

Unpacking

CAUTION!
❐ Keep children and pets away from the packaging. There is a danger of suffocation!
Unpack all parts and make sure that the product contents are complete (see chapter
"Product contents") and check for any damages from transport. If you identify damages to
the components, do not use the device (!), instead contact our customer service centre.

Assembly

For assembly, you will also need a star-headed screwdriver.
Align the
holes
Screwing
Screwing Screwing
1 x handle
1. The fresh water tank (3) has already been installed in the
midsection. Remove it before assembly by fi rst depressing
the release button (2) and then pulling it out. Mount the mid-
section on the main unit as shown.
2. Insert the handle in the opening on the midsection and align
it so that the curved end of the handle is on the back of the
device. The handle will lock into place in the right position.
3. Screw the 3 enclosed screws into the threading on the back
of the midsection (see fi gure) and tighten them with a star-
headed screwdriver.
19
1 x fresh water
tank
3 x screws