Replacing The Lamp; Installation - Electrolux SB339NCN Benutzerhandbuch

Problem
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.

7. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The FastFreeze function
is switched on.
The ShoppingMode func‐
tion is switched on.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the mode key pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FastFreeze func‐
tion".
Refer to "ShoppingMode
function".
57