Yamaha YSP-2700 Kurzanleitung Seite 14

1 2 3 4 5
SYSTEM
MEMORY
ENTER
RETURN (
14 d Auto setup for appropriate surround effects (IntelliBeam)
En
4
Press the ENTER key to start the AUTO SETUP
procedure and then leave the room within 10
seconds.
The screen
changes
automatically as
measurement
progresses.
)
If the AUTO SETUP procedure is complete, this unit rings
the chimes.
• The AUTO SETUP procedure takes about 3 minutes.
• To cancel the AUTO SETUP procedure after it is started, or if you do not
want to apply the results, press the RETURN (
• If an error occurs, an error buzzer sounds and an error message is
displayed. For details on error messages, see page 36 in the Owner's
Manual.
5
Press the ENTER key.
The measurement results are applied and saved in the unit.
• You can save several measurement results by pressing
the SYSTEM MEMORY 1, 2, or 3 key.
When the SYSTEM MEMORY 1 key is pressed, "M1
Saving" is displayed, and settings are saved.
• If ambient noise is picked up after measurement begins,
an error message is displayed in the "AUTO SETUP
) key.
COMPLETE" screen prompting you to begin
measurement again. Press the ENTER key to exit the
error message screen, and begin measurement again.
• See page 46 in the Owner's Manual for more information on the system
memory function.