Auto-Mix Color Mode
In order to select Auto-Mix Color Mode, set dipswitches 9 and 10 to ON and dipswitch 8 to OFF.
Speed (increasing) can be controlled by setting the dipswitches 1 - 7 to ON.
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the Projector
Set the dipswitch 10 to OFF. At least 1 dipswitch (from 1 – 9) must be set on ON.
Dipswitches 1 – 9 set the DMX addresses.
Addressing
Each device occupies 6 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
20/41
00026128.DOC, Version 1.4