Eliminating Minor Faults Yourself - Bosch KGF Serie Gebrauchsanleitung

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice, even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Displays do not
illuminate.
Display indicates
E..".
alarm"
is displayed.
38
Possible cause
Power failure; the fuse has been
switched off; the mains plug has
not been inserted properly.
Electronics module defective.
At some time the Variofreezer
compartment has been too warm
due to a malfunction.
Remedial action
In some cases it is adequate to switch
off the appliance for 5 minutes.
If the temperature is too high, wait a few
hours and check whether the temperature
has approached the set value.
If the temperature is too low, check the
temperature again the next day.
Check whether the power is on, the fuse
must be switched on.
Call customer service.
When the button, Fig. 2/6, has been
pressed, the display, Fig. 2/5, stops
flashing. The warmest temperature
reached in the Variofreezer compartment
is indicated on the display for ten seconds.