Normal Operation; Operating Individual Devices - Medion MD 81035 Anleitung

Code searching by brand name
This function offers you the option of searching by brand
name. You can find the brand name in the Code Table under
"Code Search by Brand Name". This is done as follows:
1. Switch the relevant device on manually.
2. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
3. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
4. Enter the one digit code according to the following
table:
Key 1 = Medion, Tchibo
Key 2 = Philips, Radiola, Philco, Erres, Pye
Key 3 = Sony, Akai, Panasonic, JVC, Sharp, Toshiba,
Daewoo
Key 4 = Thomson, Brandt, Fergusson
Key 5 = Saba, Nordmende, Telefunken
Key 6 = Grundig, Blaupunkt
Key 0 = all brands.
5. Continue pressing the P+ key (or for video recorders
POWER or
gly. Proceed quickly otherwise the automatic code
search will start.
6. Save the code by pressing OK.
If all the codes have been searched, the source key will flash
for approx. 3 seconds.
Code identification
Code identification gives you the opportunity to determine
codes that have already been entered and stored in the re
mote control. Proceed as follows:
1. Switch the relevant device on manually.
2. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
3. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
4. Briefly press the SETUP button. The source key will
briefly extinguish after the key has been pressed.
5. To find the first number, press the number keys from 0
to 9. If the source key extinguishes briefly, then it is the
first stored number.
6. To determine the second number, press the number
keys again from 0 to 9. Repeat the procedure for the
third number.
7. The source key will extinguish as soon as the button for
the third number has been pressed.
Code identification has now been completed.

Normal operation

Operating individual devices

After you have finished programming your remote control
for your audio/video devices, the remote control will work in
the common main functions just like the original remote
control of the respective device.
Point your remote control at the desired device and press
the relevant source key. The key will light up briefly but will
not remain lit.
), until the device responds accordin
6