Linear Connection Between Two Screens - Konig + Neurath INSIDE.25 Montageanleitung

Assembly instructions
for Inside 25 room partitioning system
These assembly instructions contain all the information needed to assemble
and reconfigure the Inside 25 partitioning system. The individual steps are
numbered as required, and the different tool sizes are stated.
1. Linear connection
between two screens
(a) Remove protective caps
from the top and bottom.
(b) Position the linear
connectors in the gap at the
bottom of the screen and fix in
place with a connecting bolt,
first tighten the bolt fully and
then unscrew by a 1/2 - 3/4
turn.
(c) Position the second screen
on the lower linear connector.
(d) Position the upper linear
connector in the gap between
the two screens and bolt in
place (SW 3).
(e) Snap off the lugs on the
protective caps (predetermined
breaking point).
(f) Put the protective caps on
the top to cover gaps between
the screens.
For information: only one
connecting bolt is needed for
each lower connector (b)!
(a)
(b)
(d)
17
(c)
(e)
snap off!
(f)