Sharp XV-Z7000U Anleitung Seite 16

XV-Z7000U/E
AN-Z7T
4. Removing the front duct unit, PC interface main and sub PWB units, and
optical mechanism unit
4-1. Remove the lock screw (silver) from the bimetal and detach the bimetal.
4-2. Remove the two lock screws (one in black, the other in silver) from the front duct unit and detach the front
duct unit.
4-3. Remove the one lock screw (yellow) from the PC interface sub PWB unit. Disconnect the connectors and
peel the Teflon tape that secures the connector lead wires on the optical mechanism unit. Detach the PC
interface sub PWB unit from above.
4-4. Remove the two lock screws (yellow) from the PC interface main PWB unit. Detach this unit from above.
4-5. Remove the two lock screws (silver) from the lamp socket holder and detach the lamp socket holder.
4-6. Remove the three lock screws (two in black, one in yellow) from the optical mechanism unit and detach the
optical mechanism unit from above.
Front duct unit
4-2
4-3
PC interface
sub PWB unit
4-1
4-6
4-5
16
4-4
PC interface
main PWB
unit
4-6
Teflon tape
4-3
Optical
mechanism
unit
Bottom panel