Assembly instructions for the Wave Explorer model boat, Order No. 2016
Model description
Ready-made model boat (RTR)
•
Vacuum-moulded hull and deck, pre-joined
•
Powerful SPEED 600 electric motor with Hydro drive system
•
Glass fibre reinforced plastic Hydro drive unit
•
Stainless steel drive shaft and rudder shaft
•
Drive shaft and rudder shaft supported in stainless ballraces
•
Variable drive shaft angle for optimum speed
•
Water-cooled motor, rudder linkage sealed with rubber bellows
•
Receiver, rudder servo, motor switch servo and mechanical switch factory-installed in watertight RC box
•
Set contents: hull and deck, pre-joined, cockpit cover, motor, propeller shaft and drive system
•
Boatstand, decals already applied, small items
•
Specification
Overall length approx.
Hull length approx.
Beam approx.
All-up weight approx.
Manufacturer's declaration from Graupner GmbH & Co. KG
Content of the manufacturer's declaration:
If material defects or manufacturing faults should arise in a product distributed by us in the Federal Republic
of Germany and purchased by a consumer (§ 13 BGB), we, Graupner GmbH & Co. KG, D-73230
Kirchheim/Teck, Germany, acknowledge the obligation to correct those defects within the limitations
described below.
The consumer is not entitled to exploit this manufacturer's declaration if the failure in the usability of the
product is due to natural wear, use under competition conditions, incompetent or improper use (including
incorrect installation) or external influences.
This manufacturer's declaration does not affect the consumer's legal or contractual rights regarding defects
arising from the purchase contract between the consumer and the vendor (dealer).
Extent of the guarantee
If a claim is made under guarantee, we undertake at our discretion to repair or replace the defective goods.
We will not consider supplementary claims, especially for reimbursement of costs relating to the defect (e.g.
installation / removal costs) and compensation for consequent damages unless they are allowed by statute.
This does not affect claims based on legal regulations, especially according to product liability law.
Guarantee requirements
The purchaser is required to make the guarantee claim in writing, and must enclose original proof of
purchase (e.g. invoice, receipt, delivery note) and this guarantee card. He must send the defective goods to
us at his own cost, using the following address:
Graupner Service UK
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! Liability for printing errors excluded. We reserve the right to introduce modifications.
Sous réserve de modifications! Nous ne sommes pas responsables d'éventuelles erreurs d'impression!
930 mm
840 mm
255 mm
1.75 kg
Brunel Drive
GB, NEWARK, Nottinghamshire
NG242EG
Tel. (+44) 16 36 61 05 39
Fax: (+44) 16 36 60 52 55
Email: service.uk@graupner.com
CE
11
02/2008