6. Commissioning, operation
6.1
Main display
The display of the model CEP6100 documenting multi-function calibrator is subdivided
into 3 main sections: the upper display, the lower display and the menu bar.
The upper display is used for the measurement of direct current voltages, direct
■
current (with or without loop voltage) and for pressure measurement.
The lower display can be used both for measurement and for simulation.
■
The menu bar (at the bottom of the display) serves for configuration of the upper and
■
lower display (according to the desired function).
The following figure shows the location of the various display fields, which are described
in the table.
7
6
5
Numeric display
1
Displays the numeric value of the measured or simulated signal.
A measurement "OL" or "-OL" signals a value outside of the measuring range.
Display of the span
2
Only for the display "mA" and "mA LOOP".
Displays the current measured value with respect to 4 mA = 0 % and 20 mA = 100 %.
Units
3
Displays the corresponding unit for measurement or output/simulation.
For "RTD" (resistance thermometer) and "TC" (thermocouple), °C or °F are offered; for
"FREQ" (frequency) and "PULSE" (pulse), CPM, Hz or kHz.
WIKA operating instructions model CEP6100
1
mA IN
0.000 mA
RTD IN 4W
-OL
MENU
LIGHT
-25.00%
P10-385
°C
EN
2
3
4
17