Yamaha TT-R125E Handbuch Seite 444

1
3
U P
2
a
3
FRONT BRAKE (TT-R125LWE)
Brake master cylinder
1. Install:
NOTE:
Install the brake master cylinder bracket so
G
that the arrow mark a face upward.
First tighten the bolts on the upper side of the
G
brake master cylinder bracket, and then
tighten the bolts on the lower side.
2. Install:
NOTE:
Apply the lithium soap base grease on the
G
bolt and brake lever sliding surface.
Apply the molybdenum disulfide grease on
G
the tip of the adjuster bolt.
Brake hose
1. Install:
Always use new copper washers.
CAUTION:
Install the brake hose so that its pipe por-
tion a directs as show and lightly touches
the projection b on the brake caliper.
5 - 20
Brake master cylinder 1
G
Brake master cylinder bracket 2
G
Bolt (brake master cylinder bracket) 3
G
9 Nm (0.9 m · kg, 6.5 ft · lb)
Brake lever 1
G
Spring 2
G
Bolt (brake lever) 3
G
7 Nm (0.7 m · kg, 5.1 ft · lb)
Nut (brake lever) 4
G
7 Nm (0.7 m · kg, 5.1 ft · lb)
Copper washer 1
G
Brake hose 2
G
Union bolt 3
G
26 Nm (2.6 m · kg, 19 ft · lb)
WARNING
CHAS
New