Yamaha TT-R125E Handbuch Seite 366

CDI MAGNETO AND STARTER CLUTCH
b
1
a
a
2
E
2
1
3
4 - 61
3. Install the starter clutch 1 on the rotor 2.
NOTE:
Install the starter clutch with its plate portion
G
a facing the rotor.
Insert the plate portion of the starter clutch
G
so that it is flush with the surface of contact
b with the rotor.
4. Tighten:
Bolt (starter clutch)
G
30 Nm (3.0 m · kg, 22 ft · lb)
NOTE:
Caulk a the end of the starter clutch holding
bolt near its outer diameter to serve as a stop-
per.
5. Install:
Starter wheel gear 1
G
Woodruff key 2
G
Rotor 3
G
NOTE:
Clean the tapered portion of the crankshaft
G
and the magneto hub.
When installing the magneto rotor, make
G
sure the woodruff key is properly seated in
the key way of the crankshaft.
Apply the engine oil on the starter wheel
G
gear inner circumference.
6. Tighten:
Nut (magneto) 1
G
80 Nm (8.0 m · kg, 58 ft · lb)
NOTE:
Tighten the nut (magneto) 1 while holding the
magneto 2 with a sheave holder 3.
Sheave holder:
YS-1880-A/90890-01701
ENG