teutonia Mistral S Bedienungsanleitung Seite 14

INT
MISTRAL S
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the
safety bar has clicked into place on both sides. To re-
move it, press the release buttons on the insert pieces.
In order to make it easier for your child to get in and out,
it suffices to release and fold up one side of the bar.
Special features of the model variations
Note: The brake should only be used to slow the wheels,
not to block them.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
Maintenance:
-
The brake pads can wear out during use and the brake
needs maintenance. The setting of the brake can be
done on the brake lever when the lock nut is loosened
and the adjusting bolt is unscrewed.
-
If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the
brake housings near the wheels.
-
The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that the
braking effect is the same on both wheels.
14
Models with deceleration
brake:
You are able to control the de-
celeration brake using the
brake on the handlebar. The
braking action can be fine-
tuned using the adjustment
screw on the brake lever.
Adjusting the straight-running stability
Shade holder on pram