Turning On The Display Illumination - Leica R9 Bedienungsanleitung

3.7 Frame counter for
a displaying the frame number
b Both figures flashing = Multiple exposures
c Figures flashing in the following sequence:
left / right / both = first / second / third
frame in an automatic exposure series
(bracketing, only possible with Motor-
Drive R8/R9)
d flashing = Film not loaded correctly or
not completely rewound (only when using
Motor-Winder R8/R9 or Motor-Drive R8/R9)
Turning on display illumination
The LEICA R9's rear panel display can be backlit
in blue for optimum readability even in darkness.
To turn on this backlighting, briefly press both
self-timer buttons simultaneously (1.36) when
the shutter is cocked and the camera is turned
on (see "Quick wind lever", p. 121 and "Turning the
camera on / Activating the electronics / - the
exposure metering system, p. 131).
(3.2) und
the display – regardless of whether or not a self-
timer countdown had already been entered. If
you then want to use the self-timer, the desired
countdown time must be entered again.
The illumination is then turned on along with the
displays each time the camera is turned on by
lightly tapping the shutter release (1.17) and is
extinguished along with the displays after expiry
of the idle time.
To turn the illumination off, press the two but-
tons briefly a second time. Each time the camera
is turned off by turning the exposure mode
dial (1.11) to the OFF position, it is permanently
turned off. As a result, it must be turned on as
described above when the camera is used again.
113
(3.6.f) then appear briefly in