Connection And Start-Up; A) Setup; B) Connecting Mains Adapter; Connection Of An External Amplifier - Classic Cantabile DP 210 Bedienungsanleitung

8. Connection and Start-Up

a) Setup

Set the digital piano up on a sufficiently large, level, stable surface.
Protect expensive floors from impressions and scratches with suitable pads.

b) Connecting Mains Adapter

• Turn the volume controller „VOLUME" all the way to the left counter-clockwise.
• Connect the low-voltage round plug of the enclosed mains adapter to the corresponding socket of the digital piano.
• Connect the mains adapter to a proper mains socket via the mains cable.
c) Connection of an External Amplifier
The audio signal (line level) is available at the jack plug socket „AUX OUT", e.g. for connection to an external amplifier.
Proceed as follows for connection:
• Reduce the volume at the digital piano, turn the volume controller „VOLUME" all the way to the left counter-clockwise. Switch
off the digital piano.
Also set the volume at the amplifier to the lowest setting or switch off the amplifier.
• Connect the jack plug socket „AUX OUT" e.g. to the „Aux" input of your amplifier (or another line level input, e.g. „TAPE-IN",
„CD-IN", etc. with a suitable cable. Do not use the „PHONO" input.
• Switch on the digital piano and the amplifier and set a low volume on both devices. Check the volume by playing, e.g. on the
keyboard. Increase the volume as you like.
Note:
If the volume is too high, there is the danger of hearing damage. Therefore, set the volume so that it feels comfortable
and is not too loud!

d) Connection of a Playback Device to the Digital Piano

An external playback device (e.g. an MP3 player or CD player) can be connected to the digital piano via the jack plug socket „AUX
IN".
Proceed as follows for connection:
• Reduce the volume at the digital piano, turn the volume controller „VOLUME" all the way to the left counter-clockwise. Switch
off the digital piano.
• Connect the jack plug socket „AUX IN" e.g. to the output of your MP3 player or CD player or another output with line level via a
suitable cable).
• Switch on the digital piano and the playback device and set a low volume on both devices. Start the audio playback at the play-
back device used. Increase the volume as you like.
Note:
If the volume is set too high, there is the danger of hearing damage. The digital piano's speakers may also be damaged.
Therefore, set the volume so that it feels comfortable and is not too loud!
29