Blowing Operation - Vacmaster VBV1330PF Gebrauchsanweisung

machine is fitted with a float valve that stops the suction action when the container reaches
its maximum capacity. You will notice an increase in motor speed. When this happens,
turn off the machine, disconnect from power supply, and drain the liquid into a suitable
receptacle or drain. To continue vacuuming, refit the container with the drain cap. After
wet vacuuming, turn the machine off and remove plug from power supply. Empty the
container, clean and dry the inside and outside before storage.
REMEMBER! The foam filter must be removed after wet vacuuming, and a cartridge filter
must be installed before dry vacuuming again.

BLOWING OPERATION

This Wet/Dry Vac converts to a detachable blower that can be used for leaf blowing in yards,
decks and patios. To use the detachable blower feature follow the instructions listed.
WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION: TO REDUCE THE RISK OF HEARING DAMAGE, WEAR EAR
PROTECTION WHEN USING THE VAC/BLOWER FOR EXTENDED HOURS OR WHEN
USING IT IN NOISY AREAS.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove noise diffuser from the blower port. (fig. 2)
3. While squeezing the locking lever, lift the detachable blower from the vacuum lid.
(fig.3 & 4)
4. Insert the adaptor into the blowing port and fit it the desired extension wands and or
9