Operation - Vacmaster Orson Lite VSE2101EU Bedienungsanleitung

GB
CAUTION:
brush roll when the vacuum cleaner is operating. Touching the brush roll while it is rotating
can cause personal injuries. Use caution when operating near children or pets (Fig. 6).
WARNING!
1. Charging
NOTE: Charge the battery pack for at least 4 hours before using for the first time. Never charge
the batteries in temperatures above 40°C or below 4°C. It is normal for the charging adapter to
become warm when charging.
NOTE: Only recharge your vacuum cleaner with the supplied charger.
1) Before charging, make sure the vacuum cleaner is turned OFF.
2) Choose the desired plug to fit onto the charging adapter body for the operating region (Fig. 7).
NOTE: The three pin plug is for UK, while the two pin plug is suitable for almost all other European
countries.
3) Insert the desired plug into the charging power adapter. Align the support rails located on the
charging adapter body with the guide rails on the plug insert (Fig. 8). Slide the plug insert fully
towards the charging adapter body to lock into place until you hear a click (Fig. 9).
NOTE: To remove the plug, press the release latch on the charging adapter and slide the plug
insert off the charging adapter body (Fig. 10).
4) Insert the charging adapter into the charging port on the side of the hand vacuum. Plug the
adapter into a power outlet. The battery indicator will begin to flash blue (Fig. 11).
5) The battery charging indicator light will show the progress during charging. Whilst the battery
pack is being charged, the battery charging indicator will flash blue. Once fully charged, the
battery charging indicator will show a continuous blue light.
Battery Charging Indicator
Flashing Blue Light
Continuous Blue Light
6) When fully charged, remove the charging adapter from the vacuum.
2. Using Your Vacuum Cleaner
1) To start the vacuum cleaner, press the power switch ( ① ). Once turned on, the battery power
level indicator ( ② ) will be lit (Fig. 12).
2) The vacuum cleaner has two-speed controls, LOW and HIGH. The vacuum starts in the LOW
speed position. To switch the speed to HIGH, press the speed adjustment switch ( ③ ) once.
Press the speed adjustment switch again to switch back to LOW speed (Fig. 12).

OPERATION

Moving parts! To reduce the risk of personal injury, DO NOT touch the
Do not operate the vacuum cleaner without filter in place.
Status
Charging
Fully charged
8
Battery
Charging
Indicator