Dry-Vacuum Operation - Vacmaster VBV1330PF Gebrauchsanweisung

DRY-VACUUM OPERATION

DRY VACUUMING
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter is
securely mounted. Make sure the filter is pushed in until it stops against the power head.
(fig. 2) (Your Wet/Dry Vac comes with the cartridge filter pre-installed, if not see page 11
for installation instructions.)
3. Place filter retainer on top of cartridge filter and tighten down by turning the retainer
handle clockwise. (fig. 3)
4. Place the power head back on the container, aligning the top section with the latches,
and snap into place. (fig. 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port on the front of the tank and lock in
place. Push the required attachment onto the free end of the hose or extension. (fig. 5)
6. Plug in the power cord into the outlet. (fig. 6)
7. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 7)
8. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug
the power cord from the outlet.
O = OFF
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
I = ON
7