Vacmaster VBV1330PF Gebrauchsanweisung Seite 11

nozzles. (fig.5 & 6)
5. Ensure the power switch is turned off and plug into the power supply. (fig. 7)
6. Firmly hold the blower before turning it on. Turn the motor on by flipping the switch to
the 'I' ON position. (fig.8)
MAINTENANCE
WARNING! ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
BEFORE REMOVING THE POWER HEAD FROM THE CONTAINER.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the unit. (fig. 2)
3. Undo the latches and remove the power head from the container. (fig. 3)
4. Clear all dirt or debris from the container and hose. (fig. 4)
5. Clean the foam filter by washing it with water and mild soap. (fig. 5)
6. Check the hose, attachments, and power cord to verify that they have not been
damaged.
BLOWER INTAKE
After using the blower, examine the bottom of the blower for debris and blockages and
remove if found. To clean the foam pad of the intake:
1. Verify that the power cord is disconnected from the outlet. (fig.1)
WARNING! ALWAYS DISCONNECT THE PLUG FROM THE POWER
OUTLET BEFORE REMOVING THE POWER HEAD FROM THE
CONTAINER.
2. Remove the four screws holding the intake shield and lift off the shield. (fig.2)
3. Remove the foam pad from the blower and clean the foam pad with soapy water and
allow to dry. (fig. 3)
4. Check the foam pad for reuse. If you need to replace the foam pad consult the parts list
of the manual.
5. Replace the foam pad on to the blower aligning the wholes to the screw tabs. (fig. 4)
6. Reinstall the intake shield and the four screws. (fig. 5)
10