Vacmaster VBV1330PF Gebrauchsanweisung Seite 7

GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required.
WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE
SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as listed
on page 5. (fig. 4)
5. Turn the container upside down and insert the four caster feet into the slots on the
container and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screw. (fig. 5)
6. Your vacuum comes ready for dry vacuum cleaning. If cartridge filter is not installed refer
to page 11 for filter installation. (fig. 6 & fig. 7)
7. For wet vacuum cleaning, install the supplied foam filter. (fig. 8) See page 11 for filter
installation.
8. Place the power head back on the container, aligning the top section with the latches,
and snap into place. Keep in mind to position the power head so that the blower port is
towards the rear. (fig. 9)
9. Insert the locking end of the hose into the port of the container and lock in to place.
(fig. 10)
10. Choose the desired wands or accessories and push onto the hose. (fig. 11)
NOISE DIFFUSER
For quiet operation during vacuuming, install the noise diffuser into the blower
port by inserting the locking end of the diffuser into the blower port and turning
clockwise to lock into place.
6