Blowing Operation - Vacmaster VWM1218R Gebrauchsanweisung

2. Remove cartridge filter, then carefully install the foam sleeve filter over the filter cage and place the
power head back on the container. (fig. 2) See filter installing instructions on page 12.
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS – WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (fig. 3)
4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet. (fig. 4)
5. For large amounts of liquid vacuuming, it is recommended to place the vacuum on the floor. Turn the
motor on by flipping the switch on the power head to the 'I' ON position or flip the switch to the Remote
Control Position and use the 'I' ON button on the remote control. (fig. 5 & 6)
CAUTION:
DO NOT GET THE REMOTE CONTROL WET – This will void its warranty.
6. After wet vacuuming, turn the machine off and remove plug from power supply. To prevent the risk of
possible mildew, empty the container, clean and dry the inside and outside of the container, and remove the
foam filter and allow to air dry before storage.
IMPORTANT!
liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve
that stops the suction action when the container reaches its maximum capacity. You will notice an increase
in motor speed. When this happens, turn off the machine, disconnect from power supply, and empty the
liquid into a suitable receptacle or drain. To continue vacuuming, refit the power head to the container. After
wet vacuuming, turn the machine off and remove plug from power supply. To prevent the risk of possible
mildew, empty the container, clean and dry the inside and outside of the container, and remove the foam
filter and allow to air dry before storage.
REMEMBER!
installed before dry vacuuming again.
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
WARNING:
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Make sure the container is empty before using as a blower.
3. Remove the noise diffuser from the blower port. (fig. 2)
4. Remove hose from the vacuum port and insert the locking end of the hose into the blowing port on the
power head and lock into position. (fig. 3)
GB
When vacuuming large quantities of liquids, do not immerse the nozzle completely in the
The foam filter must be removed after wet vacuuming, and a cartridge filter must be
OPERATION
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
10