Installing & Cleaning Cartridge Filter; Installing & Cleaning Foam Sleeve Filter - Vacmaster VBV1330PF Gebrauchsanweisung

INSTALLING & CLEANING CARTRIDGE FILTER
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet.
2. Remove lid and power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the
vacuum lid.Carefully push filter in until it stops against the lid. (fig.2 & 3)
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning
retainer clockwise, do not over tighten. (fig. 3 & 4)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the filter retainer by tuning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge filter up for removal. (fig. 6)
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be
done indoors in living areas.For optimal performance a new filter is recommended.
4. Install cleaned or new filter into place as instructed above in steps 2 and 3 of Installing
Cartridge Filter.
5. Wet filters should be removed and allowed to air dry for 24 hours before installing onto
the filter cage.
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS
USE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the
cartridge filter, the motor will burn out and the warranty will be voided. Always keep spare
filters on-hand.
NOTICE! The filters included are made of high quality materials designed to stop small dust
particles. The cartridge filter should be used for dry pick-up only. A dry cartridge filter is
necessary to pick up dust. If the cartridge filter is wet, it will clog quickly and be very
difficult to clean. Handle the filter carefully when removing it for cleaning and replacing it.
Check the filters for tears or small holes, a small hole can let dust pass through and out of
the cleaner. Do not use a filter with holes or tears, replace it immediately.
INSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
11