Light Bulb Replacement; Fuse Replacement - Ezgo MPT 48V Bedienungshandbuch

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Unidirectional Tires
Some vehicles may be fitted with unidirectional tires. These tires may be identified by a directional arrow on the sidewall.
Be sure to position the wheel on hub correctly with arrow indicating direction of rotation when moving forward.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not
touch new bulbs with bare fingers. Use clean, dry tissue or
paper towel to handle the glass portion of the bulb.
For vehicles with headlights, locate the two screws on back-
side of cowl that secure headlight. Remove screws, pull
headlight out and disconnect wires. Connect wires to new
headlight, install in cowl and secure with screws previously
removed.
To replace the turn signal light bulb, support turn signal housing from backside of
cowl while removing two screws securing lens. Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber bezel from around the edge of
the taillight and remove lens. Install replacement bulb and replace lens. To replace
the tail and brake light bulb, remove hardware securing lens and remove lens. Install replacement bulb.

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automotive type
fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or the Service Parts
Department.
Front of
Vehicle
Rear
Fender
Tail Light
Lens
Tail Light
Bulb
Owner's Guide
MAINTENANCE PROCEDURES
'Cross Sequence'
1
3
2
4
Tire style may vary
Turn Signal Lens
Headlight
Bulb
Inside
of Cowl
Turn Signal
Housing
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender
Page 49