effeff 495-117 Bedienungsanleitung Seite 7

Dear effeff client,
May we congratulate you on your code lock and thank your for the trust
you have placed in effeff Fritz Fuss in selecting this brand. We are
convinced that this code lock will meet your expectations. It is essential
that you read the general instructions prior to initial operation, in order
that you are able to familiarize yourself with the handling of the effeff
code lock. Correct handling and proper care are prerequisites for a long
service life and the constant operational readiness of the equipment.
Preparations prior to fitting the code lock
As the length of the lock cylinder in the existing door lock is no longer
sufficient for the code lock,s hardware, the first conversion step must be
to install a suitable lock cylinder. As an aid there is a sketch on page 22
for the purpose of determining the lock cylinder,s length. These lock
cylinders (not supplied by us) are obtainable from your local lock smith
shop.
The code lock,s spindle for the handle is envisaged for standard door
locks with a follower width of 7 mm (model 495-107 / 495-117) or 8mm
(model 495-108 / 495-118) . Special reduction bushes are enclosed to
model 495-108 and 495-118 with the installation accessoires for a
follower width of 8.5 mm or 9 mm.
In order to fit two cylinder plates to the code lock 8 countersunk head
screws M 4x8 mm are included with the installation accessoires.
Conversion of existing doors
The code lock hardware is only fittable to doors whose locks have a
backset of at least 55 mm (see page 23 for further details).
Remove the existing hardware set, handle and cylinder. Gauge and fit
the new lock cylinders (see page 22).
Fitting to new doors
Fit a standard door lock with CTC-distance (center to center) of 72 mm
and a backset of not less than 55 mm. If the ordering data specify a
different CTC-distance, appropriate cylinder plates are included with the
installation accessoires.
Gauge and fit the new lock cylinder (see sketch).
Initially place the keyboard furniture on the inside of the door and place
the drilling template on the outside of the door, in order to align it by
using the spindle of the handle and cylinder holes. Another method of
fixture is alignment using the backset chart printed on the template.
Using this select the correct backset chart is suitable for your lock. Then
cut the template to this line. By doing this, the template is alignable
precisely with the door and lock and fixable by means of adhesive tapes
(see sketch). Should the doors be rebated doors the width of the rebate
or shiplap has to be taken into consideration.
7