Technical Data; Noise/Vibration Information - Bosch GCM 10 S Professional Originalbetriebsanleitung

OBJ_BUCH-1126-002.book Page 34 Thursday, July 29, 2010 12:07 PM
34 | English

Technical Data

Sliding Mitre Saw
Article number
0 601 B20...
Rated power input
No-load speed
Weight according to
EPTA-Procedure 01/2003
Protection class
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter
Permissible workpiece dimensions (maximal/minimal) see page 39.
Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of un-
favourable mains system conditions. Malfunctions are not to be expected for system impedances below 0.15 ohm.
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.

Noise/Vibration Information

Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 94 dB(A);
Sound power level 105 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 61029:
Vibration emission value a
2
tainty K =1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 61029 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
1 609 929 X03 | (29/7/10)
... 503 ... 514
... 508
... 532
... 542
W 1800
-1
min 4600
kg 21.5
/II
mm 254
mm 1.4–2.5 1.4–2.5
mm 30
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
2
<2.5 m/s , Uncer-
ning but not actually doing the job. This may sig-
h
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
GCM 10 S Professional
... 534 ... 537
1500 1650 1800
5000 4700 4700
21.5 21.5 21.5
/II /II /II
254 254 254
1.4–2.5 1.4–2.5
30 16 25.4
... 541 ... 550
1500 1800
4300 4600
21.5 21.5
/II /II
254 254
1.4–2.5 1.4–2.5
30 25.4
Bosch Power Tools