Herunterladen Inhalt Inhalt Diese Seite drucken

Operating And Display Elements; Installation And Connection - Dometic CSMP2 Montage- Und Bedienungsanleitung

Kompressor-kühlbox
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CSMP2
5.2

Operating and display elements

No. in
fig. c,
Description
page 5
1
Temperature controller
6

Installation and connection

The cooler is installed in the drawer under the bed.
➤ Lift the mattress.
➤ Unscrew the four screws (fig. 1, page 3) and take off the board.
➤ Pull out the drawer and take out the container (fig. 2, page 3).
After you fit the cooler, you can put the container back in.
I
NOTE
If you cannot fully pull out the drawer, this is how to release it:
➤ Remove the screws (fig. 3 1, page 3) and unplug the panel beside the drawer
(fig. 3 2, page 3).
➤ Have the supply cable from slot X 7 (fig. 4, page 3) to the cooler laid by a
specialist Mercedes Benz garage.
➤ Cut out a section for ventilation at the appropriate position on the panel (fig. 5,
page 3).
➤ Push on the plate nuts supplied (fig. 6, page 3 and fig. 7, page 4).
➤ Feed the connection cable for the cooler through the hole provided (fig. 8,
page 4).
➤ Fasten the cooler with the screws provided at the appropriate positions (fig. 9,
page 4).
➤ Fasten the cooler cable to the position marked on the drawer using the clip
provided and place the rubber in the appropriate position (fig. 0, page 4).
➤ Have the cooler cable connected to the cable laid by the Mercedes-Benz garage
from the fuse box behind the cover panel (fig. a, page 4).
➤ Push the drawer back in (fig. b, page 4).
EN
Installation and connection
Explanation
– Switches the cooler on or off
– Adjusts the temperature
11

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis