Maintenance - Makita 4071D Betriebsanleitung

Cleaning (Suction)
Nozzle (Fig. 4)
Attach the nozzle to clean off tables, desks, furniture,
etc. Nozzle slips on easily.
Nozzle + Extension wand (Straight pipe) (Fig. 5)
The extension wand (straight pipe) fits in between the
nozzle and the cleaner itself. This arrangement keeps
the weight of the cleaner near your hand. It is
especially convenient for overhead cleaning or when
reach is important in close quarters.
Corner nozzle (Fig. 6)
Fit on the corner nozzle for cleaning corners and
crevice of a car or furniture. Sand and other heavy
items can be sucked up easily.
Corner nozzle + Extension wand (Straight pipe)
(Fig. 7)
In tight quarters where the cleaner itself cannot
squeeze in, or in high places hard to reach, the
extension wand (straight pipe) may be used.
Tapping out filter
When you notice less suction force during operation,
stand the cleaner so that the intake hole is in the
upright position and tap by hand the side of the
cleaner 4 or 5 times. This will unclog the pre-filter and
filter and restore suction force.
CAUTION:
Empty the cleaner before it becomes too full, or the
suction
Dust disposal
Raise the end of the cleaner so that the contents will
not fall out. Then tap by hand the side of the capsule
4 or 5 times in order to detach materials from the
pre-filter and filter and facilitate emptying. (Fig. 8)
Tip end of cleaner (with suction hole) down and
unscrew capsule as indicated in arrow direction.
Remove capsule carefully keeping it straight up and
down so that the contents will not spill out. (Fig. 9)
Empty the contents of the capsule and also the dust
adhering to the pre-filter.
Turn the pre-filter and pull it off toward you, emptying
out the fine dust inside. Then take out the filter and tap
out any adhering dust. (Fig. 10)
After emptying out the cleaner, re-assemble in the
order shown in Fig. 11.
1. Fit filter snugly on all the way.
2. Slip on pre-filter.
3. Screw on the capsule.
CAUTION:
• Failure to re-assemble the filter and/or pre-filter so
that they are back on all the way, or using a broken
or ripped filter, can cause dust to get into the motor
and result in a failure.
• Screw the capsule tightly into place. Tighten acces-
sories (nozzle, etc.) in the same direction as the
capsule screws on.
6
force weakens.
After use (Fig. 12)
When recharging or storing the cleaner, hang the
cleaner from a nail using the convenient hanger in
back.

MAINTENANCE

CAUTION:
Always be sure that the machine is switched off and
the battery cartridge is removed before carrying out
any work on the machine.
From time to time wipe off the outside (housing) of the
cleaner using a cloth dampened in soapy water.
Never use gasoline, thinner or the like or discoloration
or cracks can take place.
Rinsing out the filter in soapy water occasionally.
Never use a washing machine to clean the filter. Dry
it out thoroughly before use.
Do not use oil, benzine, thinner or the like to clean off
the cleaner itself. Cracks or discoloration will result.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
GUARANTEE
We guarantee Makita machines in accordance with
statutory/country-specific regulations. Damage attrib-
utable to normal wear and tear, overload or improper
handling will be excluded from the guarantee. In case
of complaint, please send the machine, undismantled,
with the enclosed GUARANTEE CERTIFICATE, to
your dealer or the Makita Service Center.