Bosch Indego 850 Originalbetriebsanleitung Seite 40

OBJ_BUCH-1573-008.book Page 40 Tuesday, October 27, 2015 10:35 AM
40 | English
Note: Whilst mapping the Indego will follow the wire around
the edge of the lawn area. Where the wire is run to and from
an obstacle within 1 cm as described the Indego will not de-
tect the wire but continue along the wire around the perimeter
of the lawn. (see figure 8)
Message
Is this the back of the docking
station or an obstacle? If this is
an obstacle, remove it and ma-
chine will continue mapping.
Obstacle
Mapping is complete when the machine reaches the back of
the docking station.
If the machine hasn't reached the back of the docking station
press "Obstacle" and observe information indicated on the
screen to complete installation.
If the machine has reached the back of the docking station
press "Docking Station".
Mapping Completed
Mapping Completed. Mower is
returning to the docking sta-
tion. Please wait.
Back
Indego
Invented for life
Mow now
F 016 L81 517 | (27.10.15)
After a successful installation you can either immediately be-
gin to mow by pressing "Mow now" or set up a mowing sched-
ule in the "Menu > Change Schedule".
For more information about the behaviour of the machine
while mowing see section "Mowing".
Setup of Mowing Schedule
Configure the mowing schedules and the settings of the ma-
chine according to your needs.
Approximate runtimes to complete a full garden coverage are
quoted below. Please note that the runtimes will vary depend-
ing on the lawn complexity and number of objects within the
lawn area.
2
200 m
2
500 m
Docking
Station
2
800 m
2
1000 m
2
1200 m
All menu items are listed in section "Menu Navigation".
The set up of a "Schedule" is explained in detail. The other
menus are self explaining.
Schedule
In "Menu > Change Schedule" 5 schedules are available.
"MANUAL" should be used if you only want to instruct the
machine to operate at the current time.
Each of the "CUSTOM" mode can be scheduled according to
your needs.
Example:
Info
Edit
Select a "CUSTOM" schedule with the up/down cursors, e. g.
"CUSTOM 1" and press "Edit".
Menu
2 h
6 h
9 h
12 h
15 h
Select Daily Timer
MANUAL
CUSTOM 1
CUSTOM 2
CUSTOM 3
CUSTOM 4
CUSTOM 5
Back Select
Bosch Power Tools