Bedienelemente Und Anschlüsse Am Gerät - PeakTech 1610 Bedienungsanleitung

COM Terminal
This is the negative (ground) input for all measurement modes except
current. Connection is made to it using the black test leads.
V/Hz/F/Ω Ω Ω Ω Input Terminal
This is the positive input terminal for voltage, capacitance, frequency,
ohms and diode measurements. Connection is made to it using the
red test lead.
Display
The display indicates the measured value of a signal, function mode
and annunciator.
Function/Range selector rotary switch
This rotary switch selects the function and selects the desired range.
Range Button
Press RANGE button to select the manual range mode and Turn off
the "AUTO" annunciator. (The meter remains in the range it was in
when manual reading was selected).
In the manual range mode, each time you press (RANGE) button, the
range (and the input range annunciator) increments, and a new value
is press and hold down (RANGE) button for 2 seconds. The "AUTO"
annunciator turns back on.
Hold Button
Press HOLD button to toggle in and out of the Data Hold mode. In
the Data Hold mode, the "HOLD" annunciator is displayed and the
last reading is frozen on the display. Press the HOLD button again to
exit and resume readings.
-39-
5. Bedienelemente und Anschlüsse am Gerät
1.
2.
3.
4.
5.
6.
Vorderansicht des Gerätes P 1610
(1) Zange
(3) Taste für Data-Hold /
Hintergrundbeleuchtung
(5) LCD-Display
(7) Funktionswahlschalter
(9) Hz/%duty-Taste
(11) Batteriefachdeckel
7.
8.
9.
11.
10.
(2) Zangenöffner
(4) Mode-Taste
(6) COM-Eingang
(8) Bereichswahltaste
(10) VΩ° C° F-Buchse
-12-