Restoring Factory Settings - dtm MAX II Betriebsanleitung

3
1 2
4
REMOTE
A
back toi PF
Fig. 23. Restoring the factory settings.

2.8. Restoring factory settings

PF option is used to restore the factory settings of the receiver
Factory settings of the receiver"
- no remotes registered in the memory,
- channels mode set on monostable mode with 0.5 sec turn on time,
- remote assigning of remote controls blockade: off,
- PIN blockade switched off – no PIN number,
- double-click option: off
To restore the factory settings of the receiver (fig.23) it is necessary to:
- pressA button of the receiver, after entering PIN code PP appears on the
display, from the level of main menu choose with up/down buttons 'PF'
option, confirm withA button of the receiver,
- pressA button 3 times to confirm whileA3 option shows on the display to
confirm.
Withdrawing from the changes takes place after pressing B button
A
on the receiver.
Using 'PF' option causes irreversible removal of all registered
remote controls and channel settings from the receiver's
A
memory.
A
72