dtm MAX II Betriebsanleitung Seite 57

Remote assigning of the remote control.
This function allows to assign new remotes without the necessity of physical access to the receiver button.The condition
of success is to be in the radio range of the receiver and to have remote assigned earlier.
To assign the remote to the receiver memory it is necessary to (fig.7):
- press and hold for about 15sec any button of the remote assigned earlier
- in time no longer that 3 sec from releasing the remote button press and hold for about 15 sec any button on
the remote which is to be assigned.
The remote control takes the settings of the "old" remote control which takes place in remote assigning.
REMOTE IN RECEIVER
RADIO RANGE
PRESS AND HOLD
1
FOR 15SEC BUTTON
OF „OLD" REMOTE
Remote assigning is available only for DTM433MHzSERIES remote controls.
The possibility of remote assigning the remote controls is connected with the presence of bc option in the main menu of
the receiver (see pt.2.5).
Failed assigning of the remote can be caused by:
- low battery of any of the remotes;
- radio noise which could appear during the process of remote assigning;
- full memory of the receiver (attempt to assign 701st remote);
- using the remote control button which controls the channel in the momentary mode
- active blocking of the remote assigning.
REMOTE IN RECEIVER
2
AFTER MAX. 3 SEC
57
RADIO RANGE
PRESS AND HOLD
FOR 15SEC BUTTON
OF „NEW" REMOTE Fig. 7. Remote assigning of the remote.
EN