sylvac ISP091201D Bedienungsanleitung Seite 11

5. Standby
Mode of reduced consumption without loss the reference position. The standby mode is activated automati-
cally after 20 minutes of no use. It can also be activated by pressing the [SET] key until extinction of display.
The instrument awakes automatically in case of movement detection on thimble, by a pressure on a button
or when requesting Data.
6. Full Switch off
In order to fully switch off the instrument (minimum power consumption), press the [SET] button until the
E
message «OFF» appears. At this state no data is maintained and therefore the Reference position is lost. The
«SET» message will be displayed again during the next use (see "Switching ON").
11