Troubleshooting - iSi Easy Whip Mini. PLUS Gebrauchsanleitung

Instructions for Use.
NoTe: Please observe the illustrations
"instructions for use"!
Cream should be cold when filled.
Dispense cream from the iSi Whipper shortly
before eating.
Preparation
1. Remove the decorator tip from the head.
2. Make sure that the head gasket is inserted
into the head.
3. Pour the whipping cream into the bottle.
NoTe: Please note the fill line and marking on
the bottom of the bottle. Do not overfill! The
remaining empty space is required for optimal
whipping results. Use a measuring cup.
equipment Setup.
4. Screw the head onto the bottle so that it is
straight and tighten by hand.
5. Insert the original iSi cream charger into the
charger holder.
6. Screw the charger holder with the inserted
charger onto the head until you can hear
that all of the charger contents have flowed
into the whipper.
WARNING: The whipper is now pressurized!
7. Shake the whipper vigorously > 5.
8. Unscrew the charger holder and recycle the
empty charger.
NoTe: A slight hissing noise may be heard when
removing the charger holder. This is normal.
9. Attach decorator tip to the head.
operation
10. When dispensing, the device must be held
"headfirst" (decorator tip vertical!). Gently
press the button.
NoTe: Test the consistency of the contents
when the whipper is first used. Shake the whipper
again if the consistency is still too runny.
8
Cleaning.
NoTe: Please observe the illustrations on
cleaning!
1. Press the button until the device is completely
empty and there is no pressure left. Remove
the head from the bottle and pull off the
decorator tip.
2. Remove the head gasket for basic cleaning.
3. Clean all product components by hand using
warm (not hot) tap water along with a stan­
dard cleaning agent. Clean the decorator tip
using the cleaning brush. Completely remove
any fat and egg white residue.
NoTe: Do not use scouring agents or abrasive
sponges/brushes.
NoTe: Do not put in the dishwasher and do not
wash in boiling water.
NoTe: The decorator tip can be removed at any
time for cleaning – simply rinse it with warm
water.
Storage.
If the iSi Whipper is not going to be filled again
immediately, leave the components to air dry
in a clean place and store the iSi Whipper in a
dismantled condition. Never store the whipper
with the head screwed on!

Troubleshooting.

Release the pressure:
Place the device upright, place a towel or cloth
over the tip and gently press the button until
the pressure is gone from the iSi Whipper. Now
the head can be removed from the bottle. If the
pressure will not release, please contact iSi or
your service center.
I cannot remove the content and/or the iSi
Whipper sprays.
1. There is a blockage due to undissolved
ingredients such as sugar:
9
EN