iSi Easy Whip Mini. PLUS Gebrauchsanleitung Seite 8

„Release the pressure" and then carry
out „Cleaning".
Make sure that the sugar is dissolved
completely. To sweeten, we recommend
using liquid flavouring syrup.
2. The cream has become too stiff:
Next time decrease the intensity and
frequency of the shaking cycles.
For information on the frequency of the
shaking cycles, refer to www.isi.com/
home­edition/whippedcream.
3. Content is too firm due to over­cooling:
Leave the whipper to stand at room
temperature for around 5­10 minutes.
Avoid freezing the content.
4. No pressure/not enough pressure in the device:
Only use original iSi cream chargers.
Do not reuse empty chargers. They
should be recycled immediately.
Only operate the whipper „headfirst" with
a vertical decorator tip because other­
wise there could be a loss of pressure.
5. Too many chargers were used:
Pay attention to the maximum number
of chargers to be used indicated in the
Whipper Data.
„Release the pressure" and then set­up
again.
The content being dispensed is too runny.
1. The whipper was overfilled:
„Release the pressure", pour out the excess
liquid and then set­up the whipper again.
Observe the maximum filling amounts.
2. The Whipper was not shaken or not shaken
enough:
For information on the frequency of the
shaking cycles, refer to www.isi.com/
home­edition/whippedcream.
3. The content is not cold enough:
Place a filled and prepared iSi whipper
in the refrigerator for at least 1­2 hours.
Please observe the instructions on the
cream packaging regarding optimal
preparation temperature.
4. An unsuitable charger was used:
Only use original iSi cream chargers.
10
It is difficult to screw on the charger holder
1. The charger being used is not suitable
Only use original iSi cream chargers.
The cream charger will not puncture.
1. The charger being used is not suitable:
Only use original iSi cream chargers.
2. The charger was inserted backwards:
Insert the charger correctly (see
diagram: Instructions for Use).
3. The puncturing unit has been damaged:
Send the whipper to iSi or to a service
center.
During operation, gas is leaking between
the bottle and the head.
1. The head gasket is missing:
„Release the pressure" and insert
the head gasket into the head.
2. The head gasket has been damaged:
„Release the pressure." The head gasket
needs to be replaced and is available as
an original iSi spare part.
3. The head was not tightened securely:
„Release the pressure"
Tighten the head on to the bottle
by hand as per the instructions.
4. The bottle has been damaged on the upper
edge:
„Release the pressure" and send the
whipper to iSi or a service center.
Service.
Replacement parts are available individually
and at an affordable price.
See your specialist dealer for the availability
of replacement parts. In Austria, you can also
get in contact via info@isi.com. In the US
contact isinorthamerica@isi.com
Only send in the complete whipper for repairs.
Replacement parts can be seen in greater detail
on the expanded drawing.
11
EN