For Your Safety; Switching Sauna Internal Lighting On/Off - Sentiotec A2 Montage- Und Gebrauchsanweisung

1

For your safety

CAUTION - Damage to the device:
The sauna control unit must not be doused with water or wiped with a very damp cloth. Use a
slightly dampened cleaning cloth for cleaning with a drop of mild detergent.
WARNING – Fire risk: Before switching on the sauna control unit and setting a preselected time
(time until the heater starts) it must be ensured that no combustible objects are placed on the
heater.
2

Switching sauna internal lighting on/off

1. Button 1 switches the internal sauna lighting ON/OFF.
3 Operation
3.1 Operation without preselected time
1. Press ON/OFF button 2. 00.00 appears in the display 4. The OPERATION control light 5 illuminates.
2. Press START / STOP button 8 The sauna heating heats. The HEATING control light 3 illuminates. According
to the type of device, 00.00 or the temperature measured in the temperature sensor range appears in the
display 4
3. Set the desired sauna temperature in the range 50 – 125 degrees Celsius with the rotary
TEMPERATURE knob 6.
4. To end:
4.1 Press START / STOP button 8. The sauna heating switches off. 00.00 appears in the display.
The HEATING control light 3 switches off. The control unit is ready to input another preselected time or
for a restart.
4.2 Press ON/OFF button 2. The sauna control unit is switched of.
3.2 Operation with preselected time
1. Press ON/OFF button 2 00.00 appears in the display 4. The OPERATION control light 5 illuminates.
NFORMATION – 'Fast mode':
continuous pressing of the PLUS / MINUS buttons 7 puts the input into 'fast mode' after 5 seconds.
The preselected time can be reset to 00:00 by simultaneous pressing of the two PLUS / MINUS
buttons 7.
WE DO IT FIRST.
Instructions for use for the user P. 10/16