Description - Hilti 125-D Bedienungsanleitung

Obligation signs
Wear eye Wear a hard
protection hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Alternating Rated speed
current
Diameter Double
insulated

2 Description

2.1 Use of the product as directed
The power tool is designed for cutting and grinding metal and mineral materials without use of water. Use of a guide
carriage is mandatory for cutting stone.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Working with metals: Cutting, grinding.
Working with mineral materials: Cutting and slitting using the corresponding guard (DC-EX), grinding using the
corresponding guard (DG-EX).
Use only discs (abrasive grinding discs, abrasive cutting discs, etc.) that are approved for use at a speed of at least
11000/min for a diameter of 125 mm and at least 9300/min for a diameter of 150 mm, with a maximum thickness of
6.4 mm (grinding discs) or 2.5 mm (cutting discs).
Use only synthetic resin-bonded, fiber-reinforced grinding discs or cutting discs approved for use at a permissible
peripheral speed of at least 80 m/sec.
The power tool may be used only for dry cutting or grinding.
When grinding stone, a vacuum cleaner equipped with a stone dust filter, e.g. a suitable Hilti vacuum cleaner, must be
used.
Wear ear Wear
protection protective
gloves
Volts Amps
Revolutions Revolutions
per minute per minute
Location of identification data on the power tool
The type designation, item number, year of manufacture
and technical status can be found on the type identific-
ation plate on the machine or tool. The serial no. can be
found on the left side of the motor housing. Make a note
of this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
en
19