Before Commissioning; Charging Battery - Kärcher CV 60/2 RS Bp Handbuch

Operator console
1 Horn
2 Key switch
3 Battery display
4 Operating hour counter
5 Fuse for lift unit of brush/suction head
6 Fuse for brush drive
7 Fuse for suction turbine
8 Status indicator of filter bag
9 Program selection switch
10 Driving direction switch, selected driv-
ing direction will illuminate
11 Emergency-stop button (turn to re-
lease)
Battery display
glows Battery is charged.
blinking The battery must be charged,
the brush drive is deactivated.
Status indicator of filter bag
glows green The filter bag is in good
condition
glows red No filter bag inserted or
filter bag full
Program selection switch
1 Driving, limited speed range
2 Driving, maximum speed range
3 Light cleaning intensity (eco)
4 High cleaning intensity
5 Vacuuming with the suction hose
14

Before Commissioning

Install the batteries (only Bp model)
Please observe the following warning notes
when handling batteries:
Observe the directions on the bat-
tery, in the instructions for use
and in the vehicle operating in-
structions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
Danger
Danger of explosion. Do not put tools or
similar on the battery, i.e. on the terminal
poles and cell connectors.
Risk of injury. Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Maximum battery dimensions
Length Width
350 mm 172 mm
If you use wet batteries in the Bp model,
then follow the following instructions:
It is necessary to conform to the maxi-
–
mum battery dimensions.
The battery cover needs to be opened
–
while charging wet (maintenance-free)
batteries.
While charging wet batteries, follow the
–
specifications of the battery manufac-
turer.
Battery set
3 x 12V/70Ah , mainte-
nance-free (gel)
3
-
EN
Insert batteries and connect
The Bp package model contains a built-in
battery.
The deep discharge protection of the appli-
ance is set to the respective planned bat-
tery type. If another type of battery is used,
the deep discharge protection must be re-
adjusted by customer service.
 Open the lock.
 Swivel the top of the appliance forward.
 Tilt the back of the appliance toward the
back.
1 Strut
 Insert the batteries into the appliance.
 Connect poles with the enclosed con-
necting cables.
Caution
Risk of damage. Pay attention to correct
poles.
 Connect the connection cable to the
free battery poles (+) and (-).
 Slide the battery plug through the strut
opening.
Caution
Risk of damage due to crushing. Do not
route the battery cable above the strut, but
guide it through the strut opening.
The battery can be damaged by deep dis-
charges. Charge the battery before com-
missioning the machine.
Note
Height
The appliance is equipped with a safety
236 mm
mechanism to prevent total discharge, i.e.
when the permissible minimum capacity is
reached, then the machine can only be
driven.
 Drive the machine directly to the charg-
ing station; avoid any steep gradients in
the process.
 Remove the power plug of the appli-
ance from the holder and connect it to
the mains supply.
Average charging time is approx. 10
hours.
Order No.
6.654-093.0

Charging battery