Operation - Beurer JBY 86 Gebrauchsanleitung

• You will get the maximum capacity from
your battery if you charge it at least once
every 6 months. To do this, disconnect the
device from the mains and run the bat-
tery down through normal use. Then fully
charge the battery up again.
• The maximum battery capacity can only
be reached after it has been charged sev-
eral times and is dependent on many fac-
tors (battery state, ambient temperature,
means and frequency of charging etc.).
Note
Observe the battery level indicator in the dis-
play and replace the batteries in good time.
Mains operation
Using the adapter plug, connect the units
to a socket.

6. Operation

• Position the transmitter so that it is in a
raised position at a distance of 2 m from
your baby.
• Switch the transmitter on using the on /
off / channel changer and select one of the
two channels.
• The display will begin to light up and the
selected channel is displayed.
• Switch the receiver on by selecting the
same channel as that set on the transmit-
ter. The display will begin to light up and
the selected channel is displayed.
Check the connection between the two
devices – the devices should not be more
than a metre away from each other, or this
may create feedback.
• If the transmitter is not transmitting
any sound, the symbol 'baby is asleep'
appears and the backlighting automati-
cally switches to energy saving mode.
• If the transmitter is transmitting sounds, the
symbols for 'baby is awake' appear and the
backlighting automatically switches on.
• If the connection between the two devices
is cut off, an acoustic signal sounds on the
receiver and the symbol for range con-
trol appears.
Note
Using the optical noise level monitor in the
child's room, the device can also be used by
those with hearing impairments or the deaf.
You can attach the devices to your belt using
the belt clip or hang them on the wall using
suitable fixing materials.
17