Initial Use; Battery Operation - Beurer Janosch JBY 93 Gebrauchsanweisung

6

initial use

Baby unit
You can either use the baby unit with batteries or with the supplied power
supply unit.

Battery operation

1. Loosen the screw in the battery compartment lid and remove the lid.
2. Insert two high-quality 1.5 V AAA batteries the correct way round.
3. Close the battery compartment lid and screw it back on.
The screw is a child safety feature.
Whilst charging, the power LED flashes red. As soon as the battery
is fully charged, it glows red. Please note that only the following
types of battery
mains operation
Using the power supply unit, connect the baby unit to a socket.
parent unit
Battery operation – charging
The battery must be charged for at least 10 hours before the device can be
first used independently of the mains; you may use the device during this
period. Whilst charging, the power LED flashes red. As soon as the battery
is fully charged, it glows red.
If the baby unit is used independently of the mains, the power LED begins
to flicker when the battery is low. Moreover, a beep sounds as a warning on
the parent unit every 4 seconds.
When the battery in the parent unit is low, the unit's power LED flashes
and the unit beeps every 4 seconds. If the devices are not connected to a
socket, they will switch off automatically after a short period.
can be charged in the device
25