Safety Precautions
This product complies with the requirements of the following
European Community Directives: 2004/108/EC (Electromagnetic
Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking). Overvoltage category III 600V; pollution
degree 2.
CAT I:
For signal level, telecommunication, electronic with small
transient over voltage
CAT II:
For local level, appliances, main wall outlets, portable
equipment
CAT III: Supplied from a cable under earth; fixed installed
switches, automatic cut-off or main plugs
To ensure safe operation of the equipment and eliminate the danger
of serious injury due to short-circuits (arcing), the following safety
precautions must be observed.
Damages resulting from failure to observe these safety precautions
are exempt from any legal claims whatever.
*
This Instrument must only be used and operated by a
competent trained person and in strict accordance with the
instructions. We will not accept liability for any damage or injury
caused by misuse or non compliance with instructions an safety
procedures
*
This instrument must not be used on live circuits. Ensure all
circuits are de-energised before testing.
*
Never open your analogue insulation tester except for battery
replacement (see battery replacement section)
-15-