PROCESS screen
[ ] indicates the factory setting
Item
PIXEL COMP.
PIXEL
CHECK
LENS screen
[ ] indicates the factory setting
Item
IRIS
IRIS LEVEL
When
"MANUAL" is
selected
SERVO SEL
FOCUS
When
"POSITION"
is
selected
ZOOM When
"POSITION"
is selected
Set Value
Selects whether or not white spot compensation should
[OFF]
be performed.
ON
OFF : White spot compensation not performed.
ON : White spot compensation performed.
page E28 [White spot compensation]
Detects the positions of white spots.
page E28 [White spot compensation]
Set Value
[AUTO]
Switched in accordance with the employed lens.
MANUAL
AUTO:
MANUAL:
* If the auto-iris lens cable is not connected to the [LENS]
connector, the setting automatically becomes "MANUAL".
0
Sets the iris level when "MANUAL" is selected for the IRIS
1
MODE.
•
Increasing the value:
[128]
Decreasing the value: Closes the iris
•
255
[POSITION]
Sets the lens control method.
SPEED
Normally, use the "POSITION" setting.
* If the lens control cable is not connected to the [MD
CONTROL] connector, "- - - - " is displayed.
0
Selects the focus position.
1
Increasing the value:
•
Decreasing the value: Focus nearby
[128]
•
255
0
Selects the zoom position.
1
Increasing the value:
•
Decreasing the value: Toward wide-angle
[128]
•
255
Contents
Contents
When auto-iris lens is employed.
• When manual iris lens is employed.
• No lens mounted.
• When auto-iris lens is mounted but used as
manual iris lens.
Opens the iris
Focus far away
Toward telephoto
E39